Aalborg TIO Totalizer I/O Flow Monitor/Controller Uživatelský manuál stáhnout pdf (Strana 58)

Based on interface being used, Optional Cables Kit Assemblies are available for

order. See Table 6.1 for optional GFM cables kit assemblies.

c) Input/Output Jumper Configuration

TABLE 6.1 OPTIONAL GFM CABLES AND MOUNTING KIT ASSEMBLIES

Kit Part

Number

DESCRIPTION

TIO

Input

Communication

Interface Cable

GFM Power

Supply Option

KIT-TM-

Shielded cable with two 9 pins D-con-

nectors for process signals and 6 feet

communication branch

0-5

Vdc

YES 12 and 24 Vdc

KIT-TM-

4 wires cable between GFM RJ11 and

TIO 9 pin D-connector

5-10

Vdc

NO 12 Vdc only

KIT-TM-

Flat 4 wires cable between GFM and

TIO 9 pin D-connectors

0-5

Vdc

NO 12 and 24 Vdc

KIT-TM

GFM flow meter mounting kit,

no cables

N/A N/A N/A

NOTE: For all GFM Kits (except KIT-TM) it is assumed that the power

supplied is connected to the GFM power DC jack connector and the

TIO receiving the power from the GFM.

NOTE: Your TIO device input / output jumpers were configured at

the factory according to your order. There is no need to change input

/ output jumpers’ configuration unless a different input is being

used. Before applying power and process signals, make sure the

input /output jumpers are installed in the correct position

(See Table 6.2).

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 97 98

Komentáře k této Příručce

Žádné komentáře

Aalborg TIO Totalizer I/O Flow Monitor/Controller Uživatelský manuál Strana 58

Komentáře k této Příručce

Související produkty a manuály pro Relé Aalborg TIO Totalizer I/O Flow Monitor/Controller